2.8L – 3.6L VR6 12v/24v Fluidampr Engine Damper

Code: FD-551221


Out of stock

Want to be notified when this product is back in stock?


A stock crank pulley is designed for a stock engine. When an engine is modified, the stock crank pulley does not do it’s job of keeping vibrations to a minimum. Fluidampr has a solution for that problem! Using a special design, these pullies will eliminate much of the vibration produced by your engine. That will keep your flywheel, trigger wheel, and timing gear on the crank even at high RPM usage!

The Fluidampr pullies have a precisely machined inertia ring inside along with special silicone fluid, that can absorb vibrations through all frequencies. The stock rubber dampened pulley uses rubber for dampening only for the frequency of the stock engine. These Fluidampr pullies are great for any engine setup you mave have. They do not require any frequency tuning like a stock pulley would.

You will notice engine vibrations decrease, along with decreased clutch chatter if you have a lightweight flywheel.

These are a must for a modified engine, especially if you are revving higher than stock.

Will fit all 12V and 24V VR6 engines.


PART # 551221
Fitment 1993-2008 VW / Audi. 2.8L – 3.6L VR6 12v/24v engines.
Bore Diameter 1.3788″
Degree Marking Range TDC
Degree Markings Engraved
Engine Balance Internal
Finish Black Zinc
Keyway Yes, two keys included
Length 1.571″
Material Steel
Mounting Hardware Included No
Outside Diameter 5-5/8″
Safety Rating SFI 18.1
Weight / Rotating Weight 6.1 lbs / 4.1 lbs

Additional information

Weight 1 lbs



Make Model Year Generation
Make Model Year Generation
VW GOLF R32 2004 MK4
VW GOLF R32 2008 MK5